SKAT Glue 81-10

DESCRIPTION

SKAT GLUE 81-10 is inflammable, single componenet adhesive based on synthetic modified rubber with special tackifier and additives.

It is specially developed for porous and non-porous substrats in humid and hot climatic conditions.

It has very good wet tack and cohesive as well as bond strength.

APPLICATION

Apply SKAT GLUE 81-10 with brush, roller pressure feeding equipment evenly on both surfaces, wait until solvent is fully evaporated. After the evaporation of solvent in adhesive, assemble the surface by applying normal hand pressure.
In case of fibrous wool, apply SKAT GLUE 81-10 evenly by brush or any suitable equipment ovre the GI sheet wait for 5 to 10 minutes before bonding the glass wool.

USES

SKAT GLUE 81-10 can be used in application where fibrous glass wool, or similar insulation are bonded to the interior exterior of metal duct.

 

SURFACE PREPARATION

The surface should be clean, dey and free from oil, grease and loose particles

 

OPEN TIME

10-20 minutes depending upon applied film thickness and substrate.

 

CAUTION

Adequate ventilation must be maintained, particularly in confined spaces. Due to violate in nature of solvent, keep away from source of ignition "No smoking" must be rigidly enforced in the vicinity of use. Prevent and minimize the evaporation.

 

STORAGE AND SHELF LIFE

Store under cover, protect from direct sunlight and high temparature ( less then 25oC). Shelf life is upto 12 months-in un opened container. When stored as directed.
Failure to comply with the recommended storage conditions may result in premature deterioration of the product of package, Please follow the petroleum regulation and law of the land.

 

EYE CONTACT:

Flush eyes with water for 15 mintues and call for medical help.

 

INGESTION:

Cause nausea, vomiting and loss of consciousness. If accidently swallowed do not induce vomiting rather call for medical help immedialtey.

 

HEALTH AND SAFETY

As with all chemicals, caution should always be exercised. Protective clothing such as gloves and googles should be worn.

 

INHALATION:

Inhalation of vapor or mist should be avoided, Symptoms included coughing, wheezing, laryngitis and immediately start artifical respiration, Give oxyen if breathing is labored, Get emergency medical help.

 

Skin Contact: 

Flush with water or soap and water until all traces have been removed. Seek medical attention if required

 

ADVANTAGES

  1. Excellent bonding to most porous and non-porous surfaces
  2. Water resistant
  3. Chemical resistant
  4. Suitable to Middle east climatic condition
  5. Very easy to apply
  6. Economical

 

TECHNICAL DATA
Base Synthetic modified rubber
No. of Components Single
Color Green/Transparent Yellow and Amber Red
Solid 18% - 22% w/v
Consistency Flowable liquid
Viscosity 1500 to 3000 cps (brookfield) @ 30oc
Density 0.80+0.02
Service Temp -25oC to +90oC
Flash point 20oC
Water Resistance Excellent
Chemical Resistance Good
Solubility Hydrocarbon

 

COVERAGE

The wet coverage of SKAT GLUE 81-10 is 6 to 7m2 / kg subjected to type of surface and nature of material being bonded. To get proper coverage, please always keep the containers's / spout closed to prevent solvent evaporation.

 

ClEANING

Clean all the tools with aromatic solvent.

 

PACKING

SKAT GLUE 81-10 is available in 15/18.9 Liter Metal Pail.

Warranty


NOTE: All information is given in good faith on the results gained from experience and tests. However, all recommendations or suggestions are made without guarantee since manufacturers do not have any control on site conditions and its uses.